Contact us if this information differs from the manu-facturer

• Connect the Red and White from the tanning units timer to the two Yellow Terminals on the FST Wall Switch.

• Connect pins 2 (Red) and 3 (White) from the tanning units timer to the two Yellow Terminals on the FST Wall Switch.
  - OR -
• Connect Black and Red leads from the tanning units remote bypass plug to the two Yellow Terminals on the FST Wall Switch.

• Connect the Add-On-Relay to P3 pin #1 and pin #3

• Connect the FST Timer to the FST Wall Switch normally
• Remove wire at position 6 on the Timer Board PCB1, connect it to the Red on the FST Wall Switch
• Remove wire at position 10 on the Timer Board PCB1, connect it to the Black on the FST Wall Switch
• Note: the Yellow Terminals on the FST Wall Switch will not be used.

SunStar

• Connect the Green and Yellow wires, from the Sunstar's Remote Interface Kit which is available from ETS, to the two Yellow Terminals on the FST Wall Switch.
• The FST Wall Swich must have a mechanical relay.